#Freecad mirror code
instead of Param\Rectangle.ParametricRectangle\(myObj\), you should only write ParametricRectangle\(myObj\)\r\rThe line of codes therefore become 5, as below:\r\rimport FreeCAD # module FreeCAD is not know in the macro scope, must import it\rmyObj = FreeCAD.ActiveDocumen\t.addObject\("Part::FeaturePython","Rectangle"\)\rParametricRectangle\(myObj\) # we simply reference the above defined class\ = 0 # this is mandatory unless we code the ViewProvider too\\(\)\r\r)/CreationDate(D:20160901103439+02'00')/F 4/M(D:20160901103722+02'00')/NM(85210f00-7468-4bac-8117-50742d6ad30a)/P 1003 0 R/Popup 2761 0 R/QuadPoints/RC( The lines need to be modified: \rfirst, FreeCAD must be imported \(it was imported only within the scope of the _init_ function\) second, we should not reference the module itself anymore, but only the above class, i.e. reload\(ParamRectangle\))/Rect/Subj(Highlight)/Subtype/Highlight/T(ediloren)/Type/Annot>endobj2759 0 objendobj2760 0 obj/BS 2762 0 R/C/Contents(Not fully true.
You need to use the reload\(\) functi\on, i.e. If ParamRectangle had already been imported, Python will not import it again, even if the source file has been changed, so you'd see no effect. You need to use the reload\(\) function, i.e. a toolbar visible in any workbench\)")/Rect/Subj(Highlight)/Subtype/Highlight/T(ediloren)/Type/Annot>endobj2753 0 objendobj2754 0 objendobj2755 0 obj>/ProcSet/XObject>/Subtype/Form/Type/XObject>streamĮndstreamendobj2756 0 obj/Length 9/Matrix/Resources>/Subtype/Form/Type/XObject>streamĮndstreamendobj20 R/C/Contents(I think this is wrong and does not work. you switch to another workbench and back \(if inserted under a spedific workbench\) or just switch \(if inserted under "Global", i\.e. Like most things in FreeCAD, there are many ways of making a copy."Remark: the new toolbar is NOT visible until you refresh the toolbars, i.e. Toggle the Visibility property ( Spacebar) to hide the originals and then move the copies to their correct position, for example using Std TransformManip or Std Placement. That is because the new objects have the same Placement property as their originals. If an object to be copied has links to object(s) not in the selection, FreeCAD will ask if the unselected objects should be included in the copy operation.Īfter a copy-paste operation, it may not be obvious where the new objects are located in the 3D view. For patterned clones, please look into the Other Methods section of this page. If you need neither a dependent clone nor a parametric replica, you may also use Part Workbench's Simple Copy. If you want dependent clones please use Draft Workbench's Clone or Part Design Workbench's Clone. Please consider that the copy-pasted objects are not dependent on the original.
0 kommentar(er)
